Sealing flanges and dual-mass flywheel, removing and installing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
If the specification is not obtained:
- Remove drive plate again and
install appropriate shim -1-.
Note:
Only one shim of the appropriate
thickness may be used to
compensate.
If the specification is obtained:
- Install new cylinder head bolts
and tighten hand tight.
- Tighten securing bolt to 60 Nm
plus additional 90 (
turning further can be done in
several stages).
Página 14 de 14
13-33
1
/
turn -
4
12/2/2005