Cylinder head, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
- Fill 3 mm holes in cylinder head
gasket with sealing compound
AMV 188 001 02.
Note:
When the cylinder head is installed
the holes in the cylinder head gasket
are only half visible.
- Install cylinder head, insert new
cylinder head bolts and tighten by
hand.
- Tighten cylinder head bolts in
tightening sequence as follows:
Note:
The longer cylinder head bolts must
be inserted in the middle holes of the
cylinder head.
- Pretighten all bolts to 30 Nm.
- Then tighten all bolts to 50 Nm.
- Then tighten all bolts
) further with a rigid wrench.
- Then tighten all bolts again
turn (90 ) further.
Página 42 de 58
15-35
1
/
turn (90
4
1
/
4
12/2/2005