Volkswagen Golf 1999 Service Manual page 136

Cylinder head, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
Note:
Only remove the new cylinder head gasket from
its packing immediately before installing.
Handle the new gasket with extreme care.
Damage will lead to leaks.
- Install new cylinder head gasket. Inscription
(Part No.) must be legible.
- Ensure that dowel sleeves are inserted into
cylinder block holes 12 and 20 and that cylinder
head gasket is seated.
Camshaft bar has been removed
- Position camshafts in cylinder head to TDC No.
1 cylinder.
Camshaft bar T10068 must engage in both shaft
grooves.
Note:
If the camshaft bar cannot be installed, turn engine
over (in engine direction of rotation) past TDC No.
1 and then turn back onto TDC No. 1 cyl.
Página 41 de 58
15-34
12/2/2005