Readiness code
Basic setting
Input display group number XXX
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
- Read readiness code
DTC memory has been erased or the Motronic
Engine Control Module (ECM) -J220- was
disconnected from battery (B+) positive, the
readiness code must be generated again
Page 01-149
.
If no DTC is stored:
- Press buttons -0- and -6- for the function "End
output" and confirm entry with the -Q- button.
- Switch off ignition.
- Replace front exhaust pipe with Three Way
Catalytic Converter (TWC):
Repair Manual, 2.8 Liter VR6 4V Engine
Mechanical, Engine Code(s): BDF; Repair Group
26
If "Cat B1 OK." appears in display zone 4:
- Press -C- button.
Work step 13: Fuel supply system diagnosis
(idle speed)
Indicated on display:
- Press buttons -2-, -1- and -6- for "Display group
number 216" and confirm entry with -Q- button.
Página 25 de 37
01-169
Page 01-146
. If the
12/2/2005