Readiness code
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Next&type=repair&id=...
Note:
TBV stands for Evaporative Emission (EVAP)
Canister Purge RegulatorValve -N80-.
If "TBV n. OK." appears in display zone 4:
- Press
button.
- Check DTC memory, repair Diagnostic Trouble
Codes (DTCs) if necessary and then erase DTC
memory
Page 01-23
and erasing.
- Read readiness code
DTC memory has been erased or the Motronic
Engine Control Module (ECM) -J220- was
disconnected from battery (B+) positive, the
readiness code must be generated again
Page 01-149
.
If no DTC is stored:
- Press buttons -0- and -6- for the function "End
output" and confirm entry with the -Q- button.
- Switch off ignition.
- Check breather lines to EVAP canister (may be
kinked).
Página 28 de 37
, DTC memory, checking
Page 01-146
. If the
12/2/2005
01-172