CORROSION PROTECTION - Attachment of antivibration pads
ATTACHMENT OF ANTIVIBRATION PADS
Antivibration pads are attached to the upper surface of the floor and at the interior side of the dash panel in order to absorb
vibrations and shut out exhaust gas heat. If these antivibration pads are peeled off in the course of replacement or repair
of a welded panel, cut and attach replacement material (in the shape shown in the figure). For detailed information
concerning the location where antivibration pads are to be attached for individual models, refer to the figure below.
84123-2D000
84125-2C000
84126-2C000
84171-2C000
84159-2C000
84157-2C000
84113-2D000
-2C000
84116-2C000
2C000
\
84149-2C000
84171-2C000
ANT-1100
1.
Heat the "antivibration pad" with a blow drier to soften it.
2.
Align the antivibration pad layer in the position where it is to be
installed, and then press it down with a roller or a block of wood
so that it adheres well.
NOTE
An infrared lamp can also be used to heat both the
antivibration pad layer and the body panels(be sure to wear
gloves).
127