Hyundai TIBURON Manual page 101

BODY PANEL REPAIR PROCEDURE - Rear floor and rear side member (assembly)
5. MIG plug weld the rear side members and MIG butt weld seams.
6. Prepare the welds and surfaces to which the rearfioor will attach.
7. Transcribe the outline to the new rear floor panel, adding 30mm
for overlap at the old joint.
8. Drill 8mm holes in overlap area and production locations of the
new rear floor panel for M!G plug welding.
9. Fit and clamp the rearfioor panel and attach the rearfioor panel
to the rear side members and other panels.
10. MIG plug weld all holes and MIG butt weld the seams.
11. Clean all welded surfaces.
12. Drill 8 mm holes on the flange attaching the back panel to the rear
floor and side member ends.
PRO-1640
13. Fit and clamp the back panel in place.
14. MIG plug weld the back panel.
15. Clean and prepare ail welds, remove all residue.
16. Apply the two-part epoxy primer to the interior of the rear side
members.
PRO-1650
104