Hyundai TIBURON Manual page 77

BODY PANEL REPAIR PROCEDURE - F r o n t side member (Partial)
REMOVAL
NOTE
This procedure is to be used only for repair of minor damage
to the front side member and when it is impossible to straighten
the damaged side member. The following procedure illustrates
a repair for the front left side member.
The procedure may also be applied to the front right side-
member.
1. Measure and mark the vertical outlines on front side member
outer and inner from rear edge of front side member gusset.
PRO-0300 PRO-0310
2. Drill out all the spotwelds to separate radiator support panel from
front side member.
NOTE
1. When spotweSded portions are not apparent, remove
paint with a rotary wire brush.
In order to perform cutting and separation of spotwelded
points use a spot weld cutter which is larger than the
size of the nugget to make a hole only in the panels to
be replaced.
^p^^-^Or
""\^v^r4J/
\ * •» V f
3^85
PRO-0370
80