BODY PANEL REPAIR PROCEDURE - Side sill (partial)
7.
Fit and clamp the side sill in place.
8.
MIG plug weld all holes and MIG butt weld seams.
9.
Clean and prepare all welds, remove all residue.
10. Apply body filler to the side sill outer seams.
11. Apply the two-part epoxy primer to the interior of the side si
12. Apply an anti-corrosion agent to the welded parts and interior of
the side sill (Refer to the CORROSION PROTECTION).
13. Prepare the exterior surfaces for priming, using wax and grease
remover.
14. Apply metal conditioner and water rinse.
15. Apply conversion coating and water rinse.
16. Apply the two-part epoxy primer.
PRO-1180
17. Apply the anti-corrosion primer to the side sill outer panel to
complete the repair (Referto the CORROSION PROTECTION).
PRO-1190
96