Hyundai TIBURON Manual page 81

BODY PANEL REPAIR PROCEDURE - Front pillar
REMOVAL
1. Measure and mark the each outline on the front outer pillar, front
outer upper pillar and front inner upper pillar from the windshild
glass moulding mounting hole indicated in the illustration.
2. Measure and mark the outline on front side sill outer panel as
shown in the illustration.
3. Depending on the extent of damaged area, it may be possible to
determine the cutting range within indicated in the illustration.
4. To remove the front pillar, grind away and drill out all welds
attaching the cowl side upper outer panel as illustration.
NOTE
if it is possible that the cowl side upper outer panel is
reusable, be careful not to damage it while removing.
PRO-0490
PRO-0510
PRO-0520
84