Hyundai TIBURON Manual page 82

BODY PANEL REPAIR PROCEDURE - Front pillar
5. Drill out ail welds attaching the front pillar to dash, cowl top outer
and cowl inner lower panel.
6. Remove spotwelds and lap welds attaching cowl crossmember
bar mounting upper bracket to remove front pillar.
7. Before cutting front pillar, be sure to support roof panel.
PRO-0540
8. Cut the front pillar through each cutline, taking care not to
damage the other panel as illustration.
Front pillar outer
panel 11
Side outer reinforcement
Front pillar outer upper reinforcement
Front pillar inner panel
PRO-0550
9. Before cutting the front side sill outer panel, make a rough cut the
front side sill outer panel only.
NOTE
When cutting the front side sill outer panel, he careful not
to cut side sill outer front reinforcement.
PRO-0560
85