Hyundai TIBURON Manual page 75

BODY PANEL REPAIR PROCEDURE - Fender apron and front side member (Assembly)
8. Install the cowl side upper outer panel in place.
9. MIG plug weld all holes.
10. Clean and prepare all welds, remove all residue.
11. Apply the two part epoxy primer to the interior of the each panel.
12. Apply an anti-corrosion agent as required
(Refer to the CORROSION PROTECTION).
13. Prepare the exterior surfaces for priming using wax and grease
remover.
14. Apply metal conditioner and water rinse.
15. Apply conversion coating and water rinse.
16. Apply the two-part epoxy primer.
17. Apply the correct seam sealer to all joints carefully
(Refer to the BODY SEALING LOCATION).
18. Reprime over the seam sealer to complete the repair.
19. After completing body repairs, carefully apply under coating to
the front sidemember and fender apron (Refer to the CORRO-
SION PROTECTION).
20. In order to improve corrosion resistance, if necessary, apply an
under body anti-corrosion agent to the panel which is repaired
or replaced (Refer to the CORROSION PROTECTION).
78