Hyundai TIBURON Manual page 78

BODY PANEL REPAIR PROCEDURE - Front side member (Partial)
3. Cut through the front side member inner and outer at outlines.
NOTE
Take care not to cut through front side member inner
reinforcement.
4. Prepare all surfaces to be welded.
INSTALLATION
1. Transcribe the front side member inner and outer cutline to the
new front side member, cut to length and chamfer butt end to
improve weld surface.
2. Drill 8mm holes in new front side member for MIG plug welding.
PRO-0390
3. Fit and clamp the front side member inner and outer in place.
4. MIG plug weld all holes and MIG butt weld all seams.
1 V i '
7 / \
^-^dk
r^
7^4
—c~L^-^7
i
q
°
°
\ °
o
1 | 0
1 ^ M«_
PRO0400
5. Measure each measurement point (Refer to the BODY DIMEN-
SIONS) and correct the installation position.
PRO-0410
81