Hyundai TIBURON Manual page 100

BODY PANEL REPAIR PROCEDURE - Rear floor and rear side member (assembly)
5. Remove the rear floor panel (rear section) and rear side member
from the rear body.
INSTALLATION
1. Transcribe the outline to the new rear side members. Drill out the
spotwelds attaching the inner reinforcements.
Remove remaining portions of side members.
!°: '• \<Lsy ^
T^r-^ -i-i/
-^e—~
PRO-1600
Temporarily fit and clamp the rear side members in place.
NOTE
When installing the rear floor side member, temporarily
install the back panel to measure each measurement point.
Measure each measurement point (Refer to BODY DIMEN-
SIONS) and correct the installation position.
If necessary, maketemporarity welds, andthenchecktoconfirm
that the fit of rear floor panel is correct.
* 1 o' bf t — ^- •£
^•^^ resS-^^K e o e 9 ^
IV&Hhil V U ^ ^ ^-vLJ-L/
JUL
X , > ^ V V \ i ^
w
PRO-1610
103