Hyundai TIBURON Manual page 85

BODY PANEL REPAIR PROCEDURE - Front pillar
17. Clean all welds with a disc grinder.
NOTE
1. Be careful not to grind welded portions too much.
2. The internal parts will be stronger if the weld traces are
not ground.
18. Before welding the cowl side upper outer panel, apply the two
part epoxy primer and anti-corrosion agent to the interior of the
fender apron panel.
^ S S
^ ^
^4
_ / / /
S2S3%
Pff
^
^a^
PRO-0660
19. Install the cowl side upper outer panel in place.
20. MIG plug weld all holes.
21. Clean and prepare all welds, remove all residue.
22. Apply an anti-corrosion agent to the welded parts and inside of
front pillar (Refer to the CORROSION PROTECTION).
23. Prepare exterior surfaces for priming, using wax and grease
remover.
24. Apply metal conditioner and water rinse.
25. Apply conversion coating and water rinse.
26. Apply the two-part epoxy primer.
\V_J ^x>s\
PRO-0680
Ml ^ o ,[) ///
^S_-^^^S»^^
iftfCC
PRO-0690
88