Preparation For Use - Otto Bock 757B35-1 Instructions For Use Manual

Required accessories for operation
• 1 pc. battery charger 757L35 MyoCharge Integral
• 757VAK1 battery adapter cable (only for combination with VASI system)

6 Preparation for use

6.1 Required Tools
• Screwdriver
• Adhesive tape
• 726W9=* conical drill
• Hand drill ø 4 mm
6.2 Recommended materials
• 623T1* nylon tube sock
• 99B71=* PVC sheeting
• 627B5=* Neoprene cell rubber tape
• 616T3=* ThermoLyn Trolene
• 200 617H12=* Pedilen rigid foam
6.3 Laminating instructions
The product can be positioned in the upper arm or forearm socket. Depending on how much
space is available, the battery is secured in the outer socket or between the outer and inner sock­
et.
NOTICE
Use of the product with a damaged flat cable
Malfunction due to incorrect or interrupted data transfer.
► Avoid bending or pressing the flat cable multiple times in the same position.
INFORMATION
The length of the flexible flat cable between the battery and the charging receptacle can be
adjusted by carefully bending or folding it. Only light pressure must be applied when pinching
and sliding down the folded edge. If the flexible flat cable is bent in the opposite direction at a
spot where it has already been folded, serious damage can occur.
6.3.1 Laminating instructions for the upper arm socket
1) Position the battery as far proximal as possible on the alignment aid for the ErgoArm elbow
component.
2) Use the cap screws to screw the battery to the alignment aid from the inside (see fig. 2).
3) Connect the 2-pin supply cable to the electronics housing of the elbow joint.
INFORMATION: The 3-pin communication cable is not plugged in.
6.3.2 Laminating instructions for the forearm socket
1) Fabricate the inner socket using the familiar technique.
2) Cut nylon tube sock to twice the length, pull one half over the inner socket and tie it off.
3) Establish the position of the battery dummies (on the inner socket for patients with a long
residual limb).
4) Pull the rest of the nylon tube sock down so it is free of wrinkles and tie off distally.
5) Warm the PVC sheeting and pull it over the residual limb.
6) Tie off the PVC sheeting and evacuate.
7) Glue on neoprene cell rubber tape in 2 layers according to the course of the outer socket
edge.
• 617P21=* Pedilen hardener
• 99B81=* PVA bag
• 623T* Perlon stockinette
• 616G12 carbon fibre cloth
• 616G12 carbon fibre cloth
Ottobock | 17