Otto Bock 757B35-1 Instructions For Use Manual page 14

Supply cable
The supply cable (see fig. 1, item 4) establishes the connection between the battery and the
respective prosthesis component.
3 Application
3.1 Indications for use
The product to be used exclusively to supply energy to myoelectric upper limb prosthesis com­
ponents.
3.2 Area of Application
The product has been developed for use in everyday activities. It must not be used for activities
where it would be exposed to unallowable environmental conditions or strains (e.g. extreme
sports).
3.3 Conditions of use
The product is intended exclusively for use on one patient. Use of the product by another person
is not approved by the manufacturer.
Permissible ambient conditions are described in the technical data (see Page 21).
3.4 Qualification of the prosthetist
The fitting of a patient with the product may only be carried out by an orthopaedic technician.
4 Safety
4.1 Explanation of warning symbols
Warning regarding possible serious risks of accident or injury.
WARNING
Warning regarding possible risks of accident or injury.
CAUTION
Warning regarding possible technical damage.
NOTICE
4.2 Structure of the safety instructions
CAUTION
The heading describes the source and/or the type of hazard
The introduction describes the consequences in case of failure to observe the safety instruc­
tions. Consequences are presented as follows if more than one consequence is possible:
> E.g.: Consequence 1 in case of failure to observe the hazard
> E.g.: Consequence 2 in case of failure to observe the hazard
► This symbol identifies activities/actions that must be observed/carried out in order to avert
the hazard.
4.3 General safety instructions
CAUTION
Changing prosthetic components when switched on
Injury due to faulty control or malfunction of the prosthetic system.
► Before changing prosthetic components (e.g. gripping components) switch the product off.
14 | Ottobock