Preparation For Use - Otto Bock 17BK2 Series Instructions For Use Manual

► Check the function of the orthosis joint.
► Replace damaged bearing washers.
NOTICE
Exposure of the product to unsuitable environmental conditions
Damage, brittleness or destruction due to improper handling
► Avoid storage in condensing ambient humidity.
► Avoid contact with abrasive substances (e.g. sand, dust).
► Do not expose the product to temperatures below -10 °C or above
+40 °C (e.g. sauna, excessive sunlight, drying on a radiator).
NOTICE
Contact with saltwater or water containing chlorine/soap, fresh
water or abrasive substances (e.g. sand)
Damage and premature product wear
► Following any contact with the substances identified above, promptly
clean the product in accordance with the section "Cleaning".

5 Preparation for use

Assembling the dynamic unit
CAUTION
Reaching into the area of the joint mechanism
Pinching of limbs (e.g. fingers) and the skin due to uncontrolled joint move­
ment
► Do not reach into the joint mechanism during daily use.
► Close attention is required during assembly and adjustment tasks.
NOTICE
Premature wear and tear to the guide axle of the dynamic unit
Damage to the guide axle, loss of movement in the dynamic unit and orthot­
ic joint
► Grease the guide axle (item 1) with 633F7 lubricant.
14