Before You Begin - SawStop RT-TGI Owner's Manual

BEFORE YOU BEGIN

Before mounting the Cast Iron Router Table, you may need to replace or modify your rails
or other saw components. See Page 2 for compatibility notes.
Some of the steps involve removing/installing your rails and/or extension wings.
For those steps, please refer to your table saw manual and table saw fence manual.
(Download copies of your manuals at www.sawstop.com.)
DISCONNECT YOUR TABLE SAW FROM ELECTRICAL POWER BEFORE
BEGINNING ANY MODIFICATIONS.
For Unassembled Saws:
If your saw has not yet been assembled, begin by installing and aligning the right and left
extension wings as described in the installation documentation for your table saw. Then,
install the RT-compatible front and rear rails as described in your table saw fence manual,
but do not install the tube or tighten the hardware.
RT-TGI OWNER'S MANUAL
4