SawStop RT-TGI Owner's Manual page 19

Fully tighten both screws using a 5mm
5
hex key. The mobile base is now ready
to place your saw into, but first - rotate
the rear hold-down bracket back as
far as possible and rotate the front
hold-down bracket forward as far as
possible.
To safely place the saw into the mobile
6
base, you will need at least four people
to lift the saw off the floor and then
lower it onto the mobile base. Have one
person lift each corner of the cast iron
table top. If your saw has an extension
table, have the two people on the right
side of the saw lift on the extension
rails near the outer corner of the cast
iron extension wing, not at the end of
the extension table. If a fifth person is
available, it may be easier to have four
people lift the saw and the fifth person
slide the base under the saw.
Make sure the mobile base is centered
underneath the table saw and that
the foot pedal is in the front. The saw
should sit on the two "straps" on the
interior of the mobile base, and the front
of the cabinet should be touching the
inside of the front face of the mobile
base frame.
ROTATE HOLD-DOWN
BRACKET BACK
ROTATE HOLD-DOWN
BRACKET FORWARD
The front of the cabinet
should be touching the
inside of the front face of
the mobile base frame
RT-TGI OWNER'S MANUAL
Raise
Low
Raise
Low
14