Assembling The Fence Assembly - SawStop RT-TGI Owner's Manual

Assembling the 32" Fence Assembly
Requires:
Hardware bag for 32" Fence Assembly for Router Tables (RT-F32)
Parts for 32" Fence Assembly for Router Tables (RT-F32)
Phillips Head Screwdriver
i
You will not use all of the components or hardware that come with your 32" fence. The two
32" table rails, rail rulers, rail mounting brackets, and other hardware are not used in this
configuration of the 32" Fence Assembly.
Thread a ¼" pan head Phillips screw
1
(4.11) into one of the two holes on the
side of the 2 ½" dust port (4.10), then
thread a ¼" square nut (4.12) partway
onto the end of the screw. Repeat this
process with another ¼" pan head
Phillips screw and ¼" square nut, but
thread the screw in the hole on the other
side of the dust port.
Slide the two ¼" - 20 square nuts (4.12)
2
into the lower T-slot on the back of the
router table fence (4.1) until the dust
port is aligned with the large opening
in the back of the fence. Use a Phillips
screwdriver to tighten the screws to
secure the dust port to the router
table fence.
31
RT-TGI OWNER'S MANUAL
4.10
4.12
4.12
4.1
4.11