Table of Contents
Advertisement
Locate the two self-tapping screws
7
and the two M4 x 12 x 1 washers
from the hold down kit. Some cabinet
configurations will have pre-drilled holes
for the self-tapping screws. If your saw
cabinet does not have pre-drilled holes,
or you are having difficulty aligning the
holes, rotate the rear hold-down bracket
until the top hole is over the flat face of
the cabinet. Place one of the M4 x 12 x 1
washers over the end of one of the
self-tapping screws and use a drill with
a 1⁄4 inch hex drive bit to mount the rear
hold-down bracket to the cabinet. There
is no need to pre-drill a hole for the self-
tapping screws, but be careful not to
overtighten the screws or the threads in
the cabinet may strip out.
Rotate the front hold-down bracket
8
until it is vertical and repeat the same
procedure in step 7 to mount it to the
cabinet.
•
Congratulations! You have completed the Hold-Down Strap Installation. Continue to the following
page for next steps.
15
RT-TGI OWNER'S MANUAL
rotate the rear hold-
down bracket until the
top hole is over the flat
face of the cabinet and
then mount it to the cab-
inet with a washer and a
self-tapping screw
rotate the front
hold-down bracket
until it is vertical
and then mount it
to the cabinet with
a washer and a
self-tapping screw
M4 X 12 X 1
WASHER
SELF-
TAPPING
SCREW
M4 X 12 X 1
WASHER
SELF-
TAPPING
SCREW
Advertisement
Table of Contents
