SawStop RT-TGI Owner's Manual page 18

Unscrew the M8 x 1.25 x 18 shoulder
2
socket screw at the rear-left of the
mobile base in the rear support strap,
as shown by the red arrow in the figure.
From the Mobile Base Cabinet Hold-
3
Down Kit (located in the 30" x 16" Cast
Iron Router Table box), thread the
M8 x 1.25 x 18 shoulder socket screw
through the larger hole of one of the
hold-down straps and then back into
the same hole in the rear support strap
of the mobile base. Note the orientation
of the hold-down bracket and ensure it
matches the figure to the right so that it
bends inward toward the center of the
mobile base. Finger-tighten the screw.
Repeat step 3 for the front hold-down
4
strap, making sure the hold-down strap
is in the correct orientation. Finger-
tighten the screw.
13
RT-TGI OWNER'S MANUAL
REAR SUP-
PORT STRAP
REAR SUPPORT STRAP
HOLD-DOWN
M8 X 1.25 X 18
STRAP
SHOULDER
SOCKET SCREW
REAR SUPPORT STRAP
FRONT SUPPORT STRAP
Raise
Low
Raise
Low
HOLD-DOWN
STRAP
M8 X 1.25 X 18
SHOULDER
SOCKET SCREW