Assembling And Installing The Support Legs And Power Switch - SawStop RT-TGI Owner's Manual

Assembling and Installing the Support Legs and Power Switch

Requires:
Assembled 30" x 16" Cast Iron Router Table
Power Switch (RT-PSW) Parts and Hardware Bags
Support Legs (RT-ST2) Parts and Hardware Bag
Phillips Head Screwdriver
16mm Wrench (x2)
Your existing extension table support legs are the exact same as the In-
Line Router Table Support Legs (RT-ST2). If you are planning on re-using the
support legs from your extension table, refer to your table saw fence manual
for instructions on how to remove the extension table and support legs, and
remove the brackets from the top of the support legs. You will then skip step 1
below, since you already have two assembled support legs with feet. Use the Leg
Mounting Hardware bag from the Power Switch for In-Line Router Tables box to
start at step 3.
i
The hardware for the next two steps can be found in the Support Legs for In-Line Router
Tables box.
Thread an M8 x 1.25 hex nut (2.2) all
1
the way onto a foot (2.3), then thread
the foot all the way into the base of a
support leg (2.1). Repeat this process
with another hex nut, foot, and support
leg.
i
The hardware for the following steps can be found in the Leg Mounting Hardware bag (3.23)
from the Power Switch for In-Line Router Tables box.
Align the top and third-down holes in
2
one of the support legs (2.1) with the
two holes on the inside of the right edge
of the leg mounting bracket with the
power switch (3.1) (from the perspective
of the front of the power switch).
2.1
2.2 2.3
3.1
2.1
RT-TGI OWNER'S MANUAL
16