SawStop RT-TGI Owner's Manual page 39

Slide the heads of the T-bolts into the
8
top T-slot in the front of the vertical
section of the router fence (4.1). The
semicircular, bent portion of the router
fence guard (4.15) should face away
from the router table fence. The height
of the router fence guard relative to
the router table can be adjusted by
loosening the lock knobs, moving the
router fence guard up or down, and
retightening the lock knobs.
The next step is to attach the router
9
table fence to the router table. Insert a
fence lock knob (4.2) through an
M8 washer (4.3), then through one of
the two elongated holes in the rear of
the router table fence (4.1), and then
thread a 23mm wide lock knob nut (4.4)
partway onto the end of the fence lock
knob. Repeat this process with another
fence lock knob, M8 washer, and 23mm
wide lock knob nut.
Slide the 23mm wide lock knob
10
nuts (4.4) into the round ends of the
elongated holes in your router table,
then slide the fence forward. Use the
fence lock knobs (4.2) to secure the
router fence in place.
4.2
4.3
4.1
4.4
RT-TGI OWNER'S MANUAL
4.2
34