Hold-Down Strap Installation - SawStop RT-TGI Owner's Manual

Finger tighten the hex nuts up against
4
the bottom of the table. You will adjust
the screws and fully tighten the hex nuts
later, after you install your router lift.
Your router table includes a Mobile Base
5
Hold-Down Kit (1.5). These should be
attached to your Industrial Mobile Base
now to ensure stability. If your mobile
base already has hold-down straps, the
ones included with your router table
can be discarded. Otherwise, please
complete the following steps to install
the hold-down straps. If the hold-
down straps are already installed,
or you do not have a mobile base,
proceed to page 16.

Hold-Down Strap Installation

If your saw already has the Industrial Mobile Base installed without the
hold-down straps, you will need to remove the saw from the mobile base
to install the hold-down straps before proceeding.
Unscrew the M8 x 1.25 x 18 shoulder
1
socket screw at the front-left of the
mobile base in the front support strap,
as shown by the red arrow in the figure.
FRONT
SUPPORT
STRAP
FRONT SUPPORT STRAP
RT-TGI OWNER'S MANUAL
Raise
Low
Low
12