SawStop RT-TGI Owner's Manual page 33

There are two sets of three holes in
8
the edge of your router table. Mark the
extension table in the center of each
of the three lower holes in the router
table. Then set the router table (and
attached support legs) aside.
Use a ⁄ " drill bit to drill holes in the
3
9
8
edge of the 36" extension table at the
three spots you marked in the previous
step, shown by the red arrows.
Align the three lower holes in the router
10
table with the holes you just drilled in
the 36" extension table.
RT-TGI OWNER'S MANUAL
28