Table of Contents
Advertisement
i
Once the rails are in place, you can mount the extension table to the rails. You will not use all the
hardware or brackets that are included with your 36" extension table. Follow the instructions in your
table saw fence manual to install the table. First, drill holes in the sides of the table to mount it to the
rails. Note that the holes that are closest to the wing are already drilled.
Place the extension table between the
2
rails and slide it towards the extension
wing. Be careful when positioning the
extension table because it is not yet
secured to the rails and could fall.
The extension table mounts to the
3
rails with bolts that pass through holes
in the rails and extension table. Take
two M8 flat head socket screws from
your extension table hardware, and
insert one through the hole in the front
rail closest to the saw and the other
through the hole in the rear rail closest
to the saw. Place an M8 washer, an
M8 lock washer, and an M8 hex nut on
the threaded end of each bolt, keeping
them loose.
Use a level or straightedge to make
4
sure the extension table is flush with
the right wing of your saw. Then use
two C-clamps to secure the right end
of the extension table to the rails.
Mark the extension table in the center
of the three holes in the front rail and
three in the rear rail.
RT-TGI OWNER'S MANUAL
26
Advertisement
Table of Contents
