SawStop RT-TGI Owner's Manual page 37

Insert a T-bolt (4.8) through one of the
3
six holes in the vertical portion of the
router table fence (4.1), so the head of
the T-bolt is on the front of the fence
(the side with three T-slots) and the
threaded portion of the T-bolt is on
the rear of the fence (the side with two
T-slots and the bent edge). Slide an M6
washer (4.7) onto the end of the T-bolt
and then thread a fence face plate lock
knob (4.6) onto the T-bolt, until the end
of the T-bolt is flush with the outer edge
of the lock knob. Repeat this process
for the remaining five holes in the
vertical portion of the router table fence.
Slide the T-slot in the back of a router
4
fence face plate (4.14) onto three of the
T-bolts (4.8) you just installed.
Slide the other router fence face plate
5
(4.14) onto the other three T-bolts (4.8)
you just installed. The router fence face
plates should cover the entire front of
the router fence at this time.
4.6
4.7
4.8
4.8
4.14
4.8
RT-TGI OWNER'S MANUAL
4.14
32