SawStop RT-TGI Owner's Manual page 26

Insert an M8 head bolt (3.13) through
2
an M8 washer (3.14), through one of the
holes in the left extension wing, then
through one of the holes in the router
table. Secure the bolt with another
washer (3.14), an M8 lock washer (3.15),
and an M8 hex nut (3.16). Only finger
tighten the hex nut at this time. Repeat
this process for the remaining two holes
in the extension wing and router table.
Lay a straight edge across the front of
3
the extension wing so that it extends
over the top of the router table as well.
Make sure the router table is flush with
the top of the extension wing and then
use two 13mm wrenches to tighten the
bolt and hex nut closest to the front of
the extension wing. Repeat the process
at the rear of the extension wing, then
recheck both ends and tighten the
center bolt and hex nuts.
Adjust the feet in the support legs until
4
they contact the ground and keep the
router table level. Then use a 13mm
wrench to tighten the M8 x 1.25 hex
nuts (2.2) up against the bottoms of the
support legs.
Congratulations! You have completed the In-Line Installation Left of Left Wing section. Continue
to page 31 for next steps.
21
RT-TGI OWNER'S MANUAL
3.16
3.15
3.14 3.13
3.14
3.15
3.16
2.2
3.13
3.14