In-Line Installation Right: Between 52" Rails - SawStop RT-TGI Owner's Manual

In-Line Installation Right: Between 52" Rails

Requires:
"Wing Mounting Hardware" Bag from Power Switch (RT-PSW) Box
"Rail Mounting Hardware" Bag from Power Switch (RT-PSW) Box
30" x 16" Cast Iron Router Table with Support Legs Attached
36" Extension Table
Straight Edge
13mm Wrench (x2)
⁄ " Drill Bit
3
8
Drill
C-Clamp (x2)
TGI2 Rails (CBFR Rails are NOT Compatible)
THIS PROCEDURE REQUIRES TWO PEOPLE. THE CAST IRON TABLE IS HEAVY
AND CAN CAUSE SERIOUS PERSONAL INJURY OR DAMAGE IF DROPPED.
i
The hardware for the following steps can be found in the box for your 36" extension table.
If your rails are not installed on your
1
saw, install them now according to
the instructions in your table saw
fence manual. Do not fully tighten
the hardware. If your rails are already
installed on your saw, use a 13mm
wrench to remove the main tube (set
it aside) and use a 13mm wrench
and a 5mm hex wrench to loosen the
hardware securing the rear rail to the
saw. See your table saw fence manual
for further information. (Copies of your
manuals can be downloaded at
www.sawstop.com.)
YOU WILL NOT USE ALL THE HARDWARE OR BRACKETS THAT ARE
INCLUDED WITH YOUR 36" EXTENSION TABLE.
25
RT-TGI OWNER'S MANUAL
Remove
main tube
Loosen
hardware