Table of Contents
Advertisement
ASSEMBLY AND INSTALLATION
Assembling the 30" x 16" Cast Iron Router Table
Requires:
30" x 16" Cast Iron Router Table Hardware
Phillips Head Screwdriver
Remove the protective covering from
1
the table (1.1) and wipe off the oil with a
soft, clean cloth.
Thread ten M6 hex nuts (1.2) partway
2
onto ten M6 flat head Phillips screws
(1.3).
Place the router table (1.1) upside down
3
on a flat surface and thread the
M6 flat head Phillips screws (1.3) with
prethreaded nuts into the threaded
holes around the insert opening in the
table until they extend about ¼" below
the table's top surface. These screws
will support and level the router lift
relative to the table top. The 2 holes in
the center of the opening (shown in red)
do not receive leveling screws; they will
be used later to attach the router lift to
the router table.
11
RT-TGI OWNER'S MANUAL
1.2
1.3
1.2
1.3
PAGES:
11-35
1.1
x10
1.1
Advertisement
Table of Contents
