SawStop RT-TGI Owner's Manual page 38

Tighten the six lock knobs (4.6) to
6
secure the router fence face plates
(4.14). To adjust the router fence face
plates, loosen the lock knobs on the
back of the fence and slide the router
fence face plates away from each other
until they do not interfere with the router
bit, then retighten the lock knobs.
ALWAYS MAKE SURE THE LOCK KNOBS ARE FULLY TIGHTENED BEFORE
USING THE FENCE!
Insert a T-bolt (4.8) through a router
7
fence guard spacer (4.16), with the
square part of the spacer adjacent the
head of the T-bolt and the rounded part
of the spacer facing away from the head
of the T-bolt. Repeat this process with
another T-bolt (4.8) and another router
fence guard spacer (4.16). Slide the
router fence guard (4.15) onto the two
T-bolts, so the rounded parts of the
spacers extend into the elongated
vertical holes in the router fence guard.
Secure each T-bolt (4.8) with an M6
washer (4.7) and a fence face plate
lock knob (4.6). Do not tighten the lock
knobs.
33
RT-TGI OWNER'S MANUAL
4.6
4.16
4.15
4.7
4.6
4.6
4.8