Rail Requirements: In-Line Right Of Ics Right Wing - SawStop RT-TGI Owner's Manual

Rail Requirements: In-Line Right of ICS Right Wing

Use the figures below to verify your rails are compatible with the In-Line configuration on
the right wing of your Industrial Cabinet Saw. If your rails are not already compatible,
you may choose to:
• Install your In-Line Router Table left of the left wing
• Purchase RT-Ready Replacement Rails (in green below)
• Modify your existing rails. NOTE: SawStop-approved installation requires using SawStop-
manufactured RT rails. No cut templates for rail modification are available from SawStop.
36" Rails
FRONT RAIL
Part Number: CBFR105 3600 Rails
52" Rails
REAR RAIL
FRONT RAIL
52" Industrial Rails
Part Number: CBFR104 5200 Rails
NOT COMPATIBLE
REAR RAIL
36" Industrial Rails
NOT COMPATIBLE
REAR RAIL
CORRECT HOLE
PATTERNS
FRONT RAIL
36" Industrial Series II Rails
Part Numbers: RT-TGI2-R36A
(Notice notched ends and additional
mounting holes in front and rear rails)
REAR RAIL
CORRECT HOLE
PATTERNS
FRONT RAIL
52" Industrial Series II Rails
Part Numbers: RT-TGI2-R52A
(Notice notched ends and additional
mounting holes in front and rear rails)
RT-TGI OWNER'S MANUAL
and TGI2-R36A
COMPATIBLE
and TGI2-R52A
COMPATIBLE
22