SawStop RT-TGI Owner's Manual page 34

i
The hardware for the next steps can be found in the "Wing Mounting Hardware" bag from your
Power Switch (RT-PSW) box. You will not use all the hardware from the bag.
Next, mount the router table to the
11
36" extension table using some of the
hardware from the "Wing Mounting
Hardware" bag from your Power Switch
(RT-PSW) box. Insert three M8 hex head
bolts (3.13) through three M8 washers
(3.14), then through the router table and
extension table. Secure the bolts with
three more washers (3.14), three M8
lock washers (3.15), and three
M8 hex nuts (3.16). Only finger tighten
the hex nuts at this time.
Lay a straight edge across the front of
12
the extension table so that it extends
over the top of the router table as well.
Make sure extension table is flush with
the top of the router table, and then use
two 13mm wrenches to tighten the bolt
and hex nut closest to the front of the
router table. Repeat the process at the
rear of the cast iron table, then recheck
both ends and tighten the center bolt
and hex nut. The holes in the extension
table and cast iron table are slightly
larger than the bolts they receive. This
allows some adjustment for the height
of the cast iron table relative to the 36"
extension table. To adjust the height,
push down or pull up on the router table
and then tighten the nuts.
29
RT-TGI OWNER'S MANUAL
3.16
3.15
3.14 3.13