Table of Contents
Advertisement
Insert an M10 hex head bolt (3.2)
3
through an M10 washer (3.3), then
through one of the exposed mounting
holes in the leg mounting bracket and
support leg, through another washer
(3.3), and then through an M10 lock nut
(3.4). Repeat this process for the other
set of exposed mounting holes in the
leg mounting bracket and support leg.
Use two 16mm wrenches to tighten the
lock nuts (3.4) on the bolts (3.2).
Align the top and third-down holes
4
in the other support leg (2.1) with the
two holes on the left side of the other
leg mounting bracket (3.7) (from the
perspective of the flat edge of
the bracket).
Insert an M10 hex head bolt (3.2)
5
through an M10 washer (3.3), then
through one of the exposed mounting
holes in the leg mounting bracket
(3.7) and support leg, through another
washer (3.3), and then through an M10
lock nut (3.4). Repeat this process for
the other set of exposed mounting holes
in the bracket and support leg. Use two
16mm wrenches to tighten the lock nuts
(3.4) on the bolts (3.2).
Next, mount the handle mounting bracket
6
(3.11) to the front of the leg mounting
bracket without the power switch (3.7).
Align the square hole in the handle
mounting bracket with the left of the two
holes in the front of the bracket. (The
handle mounting bracket is adjustable and
can be aligned any way the user desires to
hold the router lift elevation handle.)
17
RT-TGI OWNER'S MANUAL
3.3
3.7
3.7
3.2
3.3
ROUTER LIFT
ELEVATION
HANDLE
3.4
3.3
3.2
2.1
3.3
3.4
3.11
3.7
Advertisement
Table of Contents
