In-Line Installation Right: Between 36" Rails - SawStop RT-TGI Owner's Manual

In-Line Installation Right: Between 36" Rails

Requires:
"Rail Mounting Hardware" Bag from Power Switch (RT-PSW) Box
30" x 16" Cast Iron Router Table with Support Legs Attached
Straight Edge
13mm Wrench
5mm Hex Wrench
TGI2 Rails (CBFR Rails are NOT Compatible)
THIS PROCEDURE REQUIRES TWO PEOPLE. THE CAST IRON TABLE IS HEAVY
AND CAN CAUSE SERIOUS PERSONAL INJURY OR DAMAGE IF DROPPED.
There will be a gap between the right edge of the right cast iron extension wing of your
Industrial Cabinet Saw and the left edge of your router table. Users may choose to build
an intermediate table to install between the cast iron extension wing and router table.
Use a 5mm hex wrench and a 13mm
1
wrench to loosen the hardware securing
your rear rail to your table saw. See
your table saw fence manual for further
information. (Copies of your manuals can
be downloaded at www.sawstop.com.)
SawStop recommends removing the
main tube and loosening the hardware
securing your front rail to your table saw.
i
The hardware for the next steps can be found in the "Rail Mounting Hardware" bag included
with the Power Switch (RT-PSW) box.
Place the router table between
2
the front and rear 36" rails, at
the far right end of the rails.
Align the two mounting holes in
each end of the cast iron table
with the corresponding holes in
the rails.
23
RT-TGI OWNER'S MANUAL