Printme Cloud Printing; Setting Up Printme Cloud Printing - EFI Color Controller E-42B Configuration And Setup

A
DMINISTRATION
Follow these configuration requirements:
• You can print documents with a secure password using Fiery User Authentication (see
page
• If Direct Mobile Printing is running on more than one E-42B, be sure to assign a distinct
Bonjour name to each E-42B.
User authentication problems occur if more than one E-42B is assigned the same name.
• Verify that the E-42B is connected to a wireless access point on the network.
• Verify that supported mobile devices are connected to the same wireless network as the
E-42B.
For more information on using Direct Mobile Printing, see Printing.

PrintMe cloud printing

Users with a PrintMe subscription can upload a document to the PrintMe cloud service and
then print the document to the copier/printer using the copier control panel.
• The PrintMe feature on the E-42B requires a subscription to the PrintMe cloud service.
• For information or support related to the PrintMe cloud service, contact Electronics for
Imaging at printmesupport@efi.com.
• PrintMe availability may vary, depending on the country or region.
For more information about using PrintMe cloud printing, see Printing.

Setting up PrintMe cloud printing

You must set up the E-42B through Configure to enable PrintMe cloud printing.
T P M
O SET UP RINT E CLOUD PRINTING
1 Log on to Configure (see
2 Enable PrintMe cloud printing.
• Click PrintMe.
• Select Enable PrintMe.
(optional) If you need PrintMe cloud printing to connect to the E-42B through a
N :
OTE
proxy server, configure settings for the proxy server.
– Select Proxy Settings.
– Enable Proxy and enter proxy server information.
– Save your settings.
• Click Apply.
11).
page 43).
65