Physical Connection To The Network - EFI Color Controller E-42B Configuration And Setup

Physical connection to the network

1 Power cable
2 Power switch
I: Power ON
O: Power OFF
3 Network port (RJ-45)
4 VGA port
5 DVI port
6 USB ports
7 Crossover Ethernet port
S R
YSTEM EQUIREMENTS
Before you install the E-42B on the network, it is strongly recommended that you read
"Stages of installation on the network"
network is to physically connect the E-42B to the network. Use the network port on the
E-42B.
Use caution when shipping heavy objects. If you must lift and move heavy objects that are
connected to the E-42B, contact your service representative.
E-42B connector panel
1
2
3
4
5
6 7
6
on page 9. Step 2 of installing the E-42B on the
18