Security Setup; Filtering Setup - EFI Color Controller E-42B Configuration And Setup

S C C P 39
ETTING UP FROM THE OPIER ONTROL ANEL
Delete Scan File
1 day after scan, Manual, 1 week after scan
Choose how often to remove scanned data sent to a mailbox on the E-42B hard disk. If you
select Manual, the scan data remains on the hard disk until it is specifically deleted, or until
you clear all scan jobs.
Default Domain of Scan to SMB
Enter the default domain for Scan to SMB files.

Security Setup

You can limit access to the E-42B over your network by controlling the following:
• IP addresses
• IP ports
• 802.1x Authentication
• IPSec protocol

Filtering Setup

From the Filtering menu, you can block or accept IP addresses.
Enable IP Filter
Choose whether to enable IP filtering on the E-42B. By default, the E-42B permits all IP
addresses. Control access to the E-42B by specifying an IP address or a range of IP addresses
that the E-42B permits or rejects. This prevents unlimited access to the E-42B over your
network and ensures network security in your environment. To enter specific addresses, use
Configure.
IP addresses 0.0.0.0 and 255.255.255.255 are not valid addresses.
N :
OTE