Configuration Level; Operating The Configuration Level - Samson Trovis 6400 Mounting And Operating Instructions

CONFIGURATION level

6.4. CONFIGURATION level
The configuration blocks can be displayed and modified in the CONFIGURATION level. When
the control station operates with a code number (code number mode), the configuration blocks
can only be modified after having entered the valid code number. Configuration blocks
determine the control functions. These blocks and the associated functions are described in more
detail in Configuration manual KH 6412 E.
The configuration blocks are designated C1 to C59. The control mode selected determines
which configuration blocks are relevant. Only these blocks can be displayed and modified.

6.4.1. Operating the CONFIGURATION level

See last page of this manual for the designations of the keys and displays! Operation of this
CONFIGURATION level is described, starting from the OPERATING level. Fig. 24 is a simplified
representation of how to set a configuration block.
Accessing the CONFIGURATION level and displaying the configuration blocks
1. Press A key. I-O appears on the display.
2. Press C key several times until CO appears on the display.
3. Press A key. Now, the upper line of the display shows the setting of the configuration block
(e.g. - 1), and the associated designation of this block (e.g. C 1) is indicated in the lower
line of the display. When accessing the CONFIGURATION level for the first time, the
display always shows the configuration block which was viewed or modified last.
4. The individual configuration blocks can be viewed by pressing the C or D key.
Modifying configuration blocks
1. Follow steps 1 to 3 listed under "Accessing the CONFIGURATION level and displaying the
configuration blocks".
2. Select the configuration block to be modified by pressing the C or D key.
3. Press A key.
What comes up on the display now depends on whether the process control station
operates either with or without a code number.
If no code number was entered, CO flashes on the display. Hold down the A key for
approx. 3 s. Continue as described under 4.
If a code number was entered, CO and
set the code number in the upper digital display field (3). Then, press A key. Should CO
and still flash on the display, the wrong code number was entered. Re-enter the code
number or exit the CONFIGURATION level as described below.
C and − flash on the display.
4.
5. Select new value for the configuration block, using the C and D keys. Then, press A key to accept.
6. Select other configuration block with the C and D keys. Press A key. Continue as described
under 5. or exit the CONFIGURATION level.
Exiting the CONFIGURATION level
1. Press F key.
After having modified the configuration blocks, the control station returns to the OPERA-
TING level and is in the MANUAL mode.
36
flash on the display. Use the C and D keys to
Operation