Configuration Level; Activating And Setting Parameters - Samson 3374-10 Mounting And Operating Instructions

Configuration level
9 Configuration level
The actuator is adapted to its control task in the configuration level. The codes in this level
have a 'c' prefix to identify them.
All the parameters of the configuration level are listed in section 17.2.2 on page 83.

9.1 Activating and setting parameters

Changing settings in the configuration level
Activate the configuration level
1. Turn (when the start screen appears) to select Code 10.
2. Press to activate the configuration level.
Change parameter setting (example shown: source Code c01)
1. Press . The reading blinks on the display.
2. Turn until the required setting is reached.
3. Press to confirm the setting.
Exit configuration level
1. Turn to select the code c00.
2. Press to confirm the setting.
50 EB 8331-4 EN