Installing Control Unit; Installing Handset; Installing Legadrive Basic Handset; Fig. 17: Fixing Points On Control Unit - Hettich LegaDrive Operating And Installation Instructions

5. Transportation and installation

5.2.2 Installing control unit

Note
i
Be sure to check that the controller is suited for
the LegaDrive lifting column before assembling
the product.
Refer to the specifications on the type plates.
Observe the mains voltage.
Install the control unit underneath the desk top. To do this you
will need the following tools:
· 1 x screwdriver
· 1 x pencil,
· 1 x drill with drill bit (for predrilling).
To install the control unit proceed as follows:
1. Position control unit at chosen position on desk top,
2. Mark drill holes with pencil.

Fig. 17: Fixing points on control unit

3. Predrill these two drilling points.
4. Attach control unit at predrilled points using two screws.
Note
i
The manufacturer recommends 4 x 20 mm oval
head screws. The length of screw must be appro-
priate for the table top's thickness. Tightening
torque will depend on the table top material but
should not exceed 2 Nm.

5.2.3 Installing handset

Depending on the handset used, follow the installation instruc-
tions below:
Note
i
The position of the handset must be selected so
that no damage can occur during operation.

5.2.3.1 Installing LegaDrive Basic handset

Fig. 18: LegaDrive Basic handset

Install the handset under the desk top. To do this you will need
the following tools:
· 1 x screwdriver
· 2 - 4 x screws (depending on the type of handset)
To install the LegaDrive Basic handset under the desk top, pro-
ceed as follows:
1. Unpack handset.
Note
i
Dispose of the packaging material in an environ-
mentally friendly manner (plastic film with
plastic waste, cardboard with paper waste)!
2. Position handset at chosen position under desk top, making
sure that the handset is in easy and convenient reach.
3. Attach the handset with 2 screws.
Note
i
The following screw types must be used for atta-
ching the LegaDrive Basic handset:
- cylinder head screws
- roundhead screws
- panhead screws
Maximum thread diameter: 5 mm
Maximum head diameter: 9 mm

Fig. 19: Attaching LegaDrive Basic handset to example desk

21