Notes On Push To Open Function; Notes On Control Panel; Fig. 32: Pressing The Control Panel To Automatically Extend It; Fig. 33: Lifting And Pushing The Control Panel To Retract It - Hettich LegaDrive Operating And Installation Instructions

5. Transportation and installation
5.2.3.5.1 Notes on the push-to-open feature
The LegaDrive Touch Comfort manual switch has a push-to-open
feature which automatically extends the control panel when it is
pushed.
Note
i
To automatically extend the control panel
(push-to-open feature), it must be pushed in the
retracted position and then released. When ret-
racted the control panel must not be pulled out
to avoid the manual switch from being damaged!
Fig. 32. Pressing the control panel to automatically extend it
Fig. 33. Lifting and pushing the control panel to retract it
Note
i
The connecting cable must form a loop of at
least 10 cm to ensure proper operation of the
push-to-open feature (see figure 28).
Fig. 34. Cable loop of 10 cm min. for the push-to-open feature
5.2.3.5.2 Notes on the control panel
To prevent damage, the control panel is designed so that it deta-
ches from its anchorage under unusually high pressure (forces
applied from above).
Fig. 35. Control panel detached from above from its anchorage
Follow the steps described below to re-connect the control panel
with the moveable slide:
1. Push the spring ends into the slide seat.
Fig. 36. Spring end hooked into the lug below the slide
2. Push the control panel into the slide by pressing the marked
positions.
Fig. 37. Pushing the control panel into the slide
25