Hettich Easys ArciTech Installation Instructions Manual

Easys - ArciTech / InnoTech
Using these installation instructions
Using these installation instructions
Carefully read the safety precautions before commencing installa-
tion and starting the system.
Safety warning:
This warning sign indicates safety warnings that
must always be followed.
Intended use
easys may only be installed and used under the following
conditions:
• In dry rooms
• At temperatures ranging from 5 to 40°C
• I n conjunction with Quadro, InnoTech, ArciTech and Actro
drawer systems from Hettich
The manufacturer will not accept any liability for damage
resulting from improper installation or failure to observe these
installation instructions.
Safety warnings
easys meets the level of safety requirements applicable at the
time it was put onto the market.
• The system must only be installed, serviced, dismantled, put into
operation and adjusted by a properly trained person.
• When installing easys, observe the standards and statutory
requirements applicable in your country.
• Only connect the system to a power supply system that meets
the specifications shown on the rating plate on the power
supply unit.
• The power socket must be readily accessible while carrying out
servicing and installation work. We recommend connecting the
power supply unit to a switched power socket.
• Before commencing any cleaning or maintenance work, switch
the socket outlet off or disconnect the plug.
Make sure that no moisture is able to enter the power supply unit
(danger to life).
• Only connect the power supply unit (provided) to the easys
system for which it is intended.
• Never open the power supply unit or an automatic drive (danger
to life).
• The maximum permissible cable length from the mains plug to
the furthest easys is 10 m, max. of 6 distributors.
• Do not use damaged parts.
Hettich Marketing- und Vertriebs GmbH & Co. KG · Vahrenkampstraße 12 -16 · 32278 Kirchlengern · Telefon + 49 52 23/77-0 · www.hettich.com
!
!
Technik für Möbel
• Sharp edges may lead to damage.
• Other electrotechnical devices may interfere with the system
operation. If this occurs, contact the manufacturer or retailer of
the devices concerned.
• To prevent drawers being operated unintentionally, we
recommend connecting the power supply unit to a socket outlet
with switch and turning the switch off as
Modifications and replacement parts
Never make modifications or use replacement parts not approved
by the manufacturer as this will impair proper working order and
safety.
• Only use genuine replacement parts.
• It is only permissible for a properly trained person to change
components or make modifications to the wiring and power
supply.
Disposal
Dispose of your waste equipment at the collection point
designated by your local authority for returning and recycling
waste electrical and electronic equipment.
necessary.
5