Installing The Remote Handset Basic; Fig. 38: Remote Handset Basic; Fig. 39: Inserting / Replacing The Battery Button Cell Cr 2032; Fig. 40: Installing The Remote Handset Basic - Hettich LegaDrive Operating And Installation Instructions

5. Transportation and installation

5.2.3.6 Installing the remote handset Basic

Fig. 38. Remote handset Basic
Install the remote handset Basic under the desk top. The fol-
lowing tools are required for the installation:
· 1 x screw driver,
· 2 screws,
Follow the steps described below to install the remote handset
Basic:
1. Unpack the handset.
Note
i
Dispose of the packing material in an environ-
mentally responsible manner (plastic foil in
the plastic waste container, cardboard in the
container for waste paper)!
2. Insert the battery into the handset.
a) To do so, you have to remove the battery cover of the
handset.
b) Then insert the battery. Observe the correct battery pola-
rity.
c) Replace the battery cover on the handset.
1.
Fig. 39. Inserting / replacing the battery Button cell CR 2032
3. Place the handset in the required positon on the piece of
furniture. Make sure that the handset is easily and conve-
niently accessible.
4. Attach the handset using two screws.
26
The button cell (CR 2032, included) must be inserted (see section
6.2.2.2) before installing the remote handset Basic.
Observe the correct polarity.
3.
2.
Note
The following screw types should be used for
attaching the remote handset Basic:
- Cylinder head screws
- Round-head screws
- Flat-head screws
Max. thread diameter: 4.5 mm
Max. head diameter: 8 mm
Fig. 40. Installing the remote handset Basic
Note
i
Do not install the remote handset Basic unless
the remote receiver has been programmed (see
6.2.2.1).
Note
i
The remote handset Basic must be firmly at-
tached and used within sight of the furniture.