Changing Desk Height Unit (Cm Or Inch); Returning Control Unit To Factory Settings (S0 Menu) - Hettich LegaDrive Operating And Installation Instructions

7. Operation

7.5.8 Changing desk height unit (cm or inch)

This function lets you change the memory handset display from
centimetre to inch and vice versa. This function does not alter
desk height.
Note
i
On selecting the menu, the display shows S and
a number, e.g. S 1. This number depends on the
control unit's parameters.
No. Button
Simultaneously press memory position
1.
1 2
button 1, memory position button 2 and
the desk top down button.
2. Keep this button combination pressed for
1 2
approx. 3 seconds.
3. Now release the buttons.
1 2
4. The display shows S 1.
Keep pressing the desk top up button
until the display shows S 5.
5. The display shows S 5.
Press the SAVE-button.
SAVE SAVE
If the display was previously set to cm,
it will now be changed to inch. If the
display was previously set to inch, it will
now be changed to cm.
40
Function
7.5.9 Returning control unit to factory settings
(S0 menu)
This function allows you to return the control unit to factory
settings.
Note
i
This procedure requires a handset with display.
Note
i
On selecting the menu, the display shows S and
a number, e.g. S 1. This number depends on the
control unit's parameters.
Note
i
If lifting columns are replaced in a system, it is
imperative to return the control unit to factory
settings first and perform a manual reset (see
Section 7.4.4).