Installing Legadrive Touch Basic Handset; Installing Legadrive Touch Basic Inlay Handset; Fig. 20: Legadrive Touch Basic Handset; Fig. 21: Attaching Legadrive Touch Basic Handset To - Hettich LegaDrive Operating And Installation Instructions

5. Transportation and installation

5.2.3.2 Installing LegaDrive Touch Basic handset

Fig. 20: LegaDrive Touch Basic handset

Install the handset under the desk top. To do this you will need
the following tools:
· 1 x screwdriver
· 2 x screws
To install the LegaDrive Touch Basic under the desk top, proceed
as follows:
1. Unpack handset.
Note
i
Dispose of the packaging material in an environ-
mentally friendly manner (plastic film with
plastic waste, cardboard with paper waste)!
2. Position handset at chosen position under desk top, making
sure that the handset is in easy and convenient reach.
3. Attach the handset with 2 screws.
Fig. 21: Attaching LegaDrive Touch Basic handset to example desk
Note
i
The following screw types must be used for atta-
ching the LegaDrive Touch Basic handset:
- cylinder head screws
- roundhead screws
- panhead screws
Maximum thread diameter: 4 mm
Maximum head diameter: 7.3 mm
22

5.2.3.3 Installing LegaDrive Touch Basic Inlay handset

Fig. 22: LegaDrive Touch Basic Inlay handset

Install the handset at an appropriate position in the desk top.
To install the LegaDrive Touch Basic Inlay handset under the desk
top, proceed as follows:
1. Unpack handset.
Note
i
Dispose of the packaging material in an environ-
mentally friendly manner (plastic film with
plastic waste, cardboard with paper waste)!
2. Drill / cut out an installation hole. The cut out is illustrated
below.
R9

Fig. 23: Cut out for installing LegaDrive Touch Basic Inlay

handset with rubber fins
3. Insert the handset from above into the previously drilled hole
in the desk top. The handset is installed without additional
screws, the rubber fins hold it in position.
Fig. 24. Attaching LegaDrive Touch Basic Inlay handset
to example desk
26,9
64,6