Plugging In Power Supply Cable; Overall Configuration (Example); Fig. 47: Example Configuration - Hettich LegaDrive Operating And Installation Instructions

6. Start-up

6.2.4 Plugging in power supply cable

Warning
Warning!
Before plugging in the power supply cable (so-
cket P), check once again to make sure that
· the mains voltage is the same as the mains vol-
tage shown on your control unit's rating plate,
· all components are connected to the right
sockets,
· the earth cable is attached!
HS
M1
M2
M3
The control unit is ready for operation once the
power supply cable has been plugged in.
When installing the power supply, it must be en-
sured that the control unit can be disconnected
from the power supply at any time.
Note
i
A manual reset may be necessary if there is a po-
wer cut or if the power supply cable is unplugged
while adjusting height (see Section 7.4.4).
Warning
Warning!
When laying the cables, make sure they are not
pinched, kinked or stripped of their insulation.
When laying the supply cable, observe the
DIN EN 60335-1 (VDE 0700-1).
Warning
Warning!
When laying the cables make sure that no one
can trip over them (e.g. mains connection cable).
Warning
Warning!
When laying the cables, make sure you allow
sufficient cable length for height adjustment.
30
D
F
P
Note
i
In this context, also follow the rules and re-
gulations usually applied in the industry, such
as those collated in the "Guideline - Electrical
Installations in Office Furniture", published by
buero-forum which belongs to bso Verband Büro,
Sitz- und Objektmöbel e.V., the German associ-
ation for office furniture, seating and contract
furniture.

6.3 Overall configuration (example)

In the illustration below you can see the socket assignment for an
example configuration. This example configuration comprises:
· 1: a LegaDrive COMPACT-e-2 type control unit.
· 2: a desk support with two LegaDrive lifting columns
· 3: a LegaDrive Basic type handset
· 4: a LegaDrive EU power supply cable.
Fig. 47. Example configuration