7. Operation
7.5.3 Safety zone
This function produces a safety stop at a defined desk top positi-
on (configured by software). The safety stop works as follows:
Note
i
Desk top positions in safety zones cannot be
memorised.
No.
Button
Press the desk top down button.
1.
Keep the desk top down button pressed
until the desk top stops automatically.
Desk top movement is stopped above the
safety zone.
Press the desk top down button again.
2.
Keep this button pressed until the desk
top reaches the height you want.
Function
7.5.4 Pedestal stop and shelf stop positions
These two features can be used to limit the desk's travelling ran-
ge (e.g. where a pedestal is standing under the desk). A pedestal
stop position can be set in the lower half of the travelling range,
a shelf stop position in the upper half. If a pedestal stop position
is set, this is used as the new end position; a shelf stop position
functions as a new upper end position for the travelling range.
To memorise a pedestal stop / shelf stop position, proceed as
follows:
Shelf-
Stop-
Position
Contanier-
Stop-
Position
min.
Fig.52. Container-Stop- / Shelf-Stop-Position
Note
i
These steps must be performed separately for a
pedestal stop position and a shelf stop position.
No.
Button
1.
Move the desk top to the position you
wish to use as the new pedestal stop /
or
shelf stop position.
To do this, press the desk position down
or desk position up buttons until the
chosen position is reached.
Simultaneously press the desk position
2.
up and desk position down buttons and
keep both buttons pressed for approx.
10 seconds. The control unit clicks twice
once the position has been memorised.
max.
Function
37